Atomizer Coil Jig
Introducing the KK Vapetek Atomizer Coil Jig. It’s basically a tool that makes wrapping coils a lot easier and consistent. The KK Vapetek coil jig includes 1/16″, 3/32″, and 1/8″ wrapping posts.
Simply remove one of the wrapping posts from the internal compartment, insert it into the top hole and tighten the set screw. Wrap one end of your coil wire around the lower set screw and tighten it. Then simply begin wrapping your coil around the wrapping post until it has as many wraps as you require. When you're done, snip the ends and remove it from the wrapping post. You can also remove the wrapping post with the coil still on it and use it as a stabilization tool to attach it to your rebuildable atomizer